Multi-tech-systems MULTIVOIP MVP210/410/810 Uživatelský manuál stáhnout pdf (Strana 15)

Chapter 2: Installing and Cabling the MultiVOIP

Multi-Tech Systems, Inc. 15

Figure 2-8. MVP-410/810 Channel Jumper Settings

5. Position the jumper for each DID channel so that it does not connect the two jumper posts. For DID

operation of a VOIP channel, the MultiVOIP will work properly if you simply remove the jumper altogether,

but that is inadvisable because the jumper might be needed later if a different telephony interface is used

for that VOIP channel.

6. Slide the main circuit card back into the MultiVOIP chassis and replace the three screws.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 143 144

MultiVOIP 1
CONTENTS 3
Chapter 1 – Description and 6
Specifications 6
Computer Requirements 7
Cabling Procedure for MVP210 11
MVP210 Circuit Board 12
RJ-11 connector) 13
MVP-410/810 14
Rear Panel 14
Setup Overview 19
Ethernet/IP 20
Voice/Fax 21
Interface 23
Call Signaling 25
Regional 27
Phone Book 28
Save & Reboot 29
Configurable Payload Type 39
FXS Loop Start Parameters 41
Message Waiting 43
FXO Parameters 44
E&M Parameters 49
DID Parameters 52
Logs/Traces 70
NAT Traversal 71
Supplementary Services 72
Save Settings 75
Connection 75
Outbound Phonebook 78
Inbound Phonebook 80
Phone Book Descriptions 81
Add/Edit Outbound Phone Book 82
PSTN Line 85
Add/Edit Inbound Phone Book 87
Phone Book Save and Reboot 89
Phonebook Examples 90
Calls at London local rates 93
Local Calling Area 93
The Netherlands 94
Figure 5-17: Setup example 95
Display shows: 100
Phone Book Configuration 100
Inbound Phone Book 100
Introduction 102
System Information screen 103
Statistics Section 104
IP Statistics 108
Link Management 110
Registered Gateway Details 111
Servers 112
SIP Proxies 113
SPP Registrars 114
Advanced 115
MultiVOIP Program Menu Items 116
C:\Acme-Inc\MVP3000-firm 117
Downloading Firmware 119
Downloading Factory Defaults 120
Downloading IFM Firmware 121
Setting a Password 124
Web Browser Interface 125
Upgrading Software 126
SysLog Server Functions 134
1 2 3 4 5 6 7 8 135
Appendix B – TCP/UDP Port 136
Assignments 136
Procedure in Detail 137
Screw locations (2) 138
Standoff/nut attachment 139
(rear bottom view) 139
Industry Canada 140
Canadian Limitations Notice 140
FCC Part 68 Telecom 141
Electronic Equipment (WEEE) 142
Statement 142
Concentration 143

Komentáře k této Příručce

Žádné komentáře

Multi-tech-systems MULTIVOIP MVP210/410/810 Uživatelský manuál Strana 15

Komentáře k této Příručce