Multi-tech-systems ISIHP-2S Uživatelský manuál stáhnout pdf (Strana 60)

Software/Driver Installation

60 MultiModemISI Hybrid Series, ISIHP-2S/2U

Note: A base I/O address of 0, e.g., ISIBaseX=oxo, or omission of

these parameters for any card X, disables that particular card.

Miscellaneous:

Device files corresponding to ports on the ISIHP-2S cards are created in

the /dev folder. Use ttyMxy for normal ports and cumxy for

corresponding callout ports. The letter x is the card number (14), and y

is the port number, (ap) for 16-port cards.

Normal ports (ttyM) are configured for dial-in connections. Callout ports

(cum) are used for dial-out connections.

To view busy I/O address space on your system, enter:

cat /proc/ioports

To view busy IRQs, enter:

cat /proc/interrupts

To load the driver manually, use insmod.

Example: To load two ISI cards configured with base I/O addresses

0x210 and 0x200 and IRQs 5 and 10, enter the following in the

destination folder:

insmod isicom

ISIBase1=0x210

Irq1=5

ISIBase2=0x200

Irq2=10

To remove the driver manually, enter rmmod isicom. This removes the

driver only if no ISI ports are in use.

1 2 ... 55 56 57 58 59 60 61 62 63

Žádné komentáře

Multi-tech-systems ISIHP-2S Uživatelský manuál Strana 60