Multi-tech-systems ISIHP-2U Uživatelský manuál stáhnout pdf (Strana 42)

Software/Driver Installation (Windows 98)

42 MultiModemISI Hybrid Series, ISIHP-2S/2U/4S/4U/4SD

4. The Install From Disk dialog box appears. Click OK.

5. The Install New Modem dialog box appears. Select a protocol

(depending on your application) from the Models list; then click

Next.

6. The Install New Modem dialog box appears. Select the port that

corresponds to the lowest numbered port of the ISIHP card. Any

ports that had been installed before installing the ISIHP card are

numbered lower than the ports of the ISIHP card. Click Next.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 154 155

User Guide 1
88311551Revision B 2
Contents 3
Introduction 10
Hardware 11
Installation 11
Computer Requirements 12
Shipping Contents 12
Safety Warnings 12
Hardware Installation 13
ISIHP-2S 14
ISIHP-2U 14
ISIHP-4S/4U 14
LED Indicators 16
ISIHP-2S LED Indicators 17
ISIHP-2U LED Indicators 18
Software 19
(usually port 3) 22
To install terminal adapters: 24
To install modems: 27
General tab 29
I/O Addresses and IRQ Codes 32
NT 3.51/4.0 33
Windows 95 Installation 34
Windows 98 Installation 36
Windows 98 39
To remove the ISIHP card: 39
To remove the drivers: 39
{not applicable to -4SD} 45
North American Users 49
International Users 50
Optional Settings 50
Software/Driver Installation 51
ISDN TA Configuration Utility 52
ConfigMenu Menus 59
Terminal Adapter AT Commands 59
{2S/2U models only} 61
Removing the Driver (Novell) 61
MultiTech Installation Script 63
To install the Linux driver: 68
Miscellaneous: 69
Warranty & Service 71
Information 71
Limited Warranty 72
Command Structure 75
Command Editing 75
Dialing Commands 79
Dial Modifier Commands 79
Phone Number Memory Commands 80
Online Connection Commands 84
RS-232 Interface Commands 86
Immediate Action Commands 89
Flow Control Commands 90
Escape Sequences 92
Modem S-Registers 94
Examples of Assigning Values 100
Examples of Reading Values 100
Modem Result Codes 101
Entering AT Commands 104
Topic Command Description 105
Command Implementation 108
Switch Configuration Commands 108
Data Call Commands 125
Terminal Adapter S-Registers 126
Terminal Adapter Result Codes 135
Modes of Operation 136
Offline Command Mode 136
Data Mode 137
Online Command Mode 137
Making a Call 137
Answering a Call 138
Answering Using Call Steering 139
Hanging Up 139
Troubleshooting 141
Data is being lost 146
There are 146
Regulatory Information 147
FCC Part 68 Telecom 148
Industry Canada 150
FCC Fax Warning 150
Canadian Limitations Notice 151

Komentáře k této Příručce

Žádné komentáře

Multi-tech-systems ISIHP-2U Uživatelský manuál Strana 42

Komentáře k této Příručce

Související produkty a manuály pro Hardware Multi-tech-systems ISIHP-2U